Knowledge of the down-hole loads provides valuable insight into Coiled Tubing drilling/ milling, fishing or any other Coiled Tubing operation.
In highly-deviated and horizontal wells, indications of load-at-surface will not be an accurate indication of what is actually happening down-hole.
With the ALS push/ Pull Memory Tool, a log of forces experienced down-hole can be compared to surface measurements and operating procedures.
After each run the data collected can be downloaded to a PC for analysis. The standard tool also incorporates a torque sensor. Temperature and pressure are also optional.
Note: This tool is also available in 1-11/16” & 2-1/8” OD
- Measures Tension, Compression & Torque
- 0.70” Bore-Through Tool
- Variable Sampling Rate
- Bend Insensitive
|Outside Diameter (in)||2.875"|
|Inside Diameter (in)||0.70"|
|Make-up Length (mm)||20 Kpsi|
|Max. Operating Temperature (C)||135|
|Max. Operating Pressure (psi)||10,000|
|Max. Differential Pressure (psi)||5,000|
|Max. Tensile Rating (lbf)||60,000|
|Max. Compression Rating (lbf)||15,000|
|Max Torque Rating (ft-lbf)||2,500|
|Tension / Compression Range (lbf)||-10,000 to 25,000|
|Torque Range (ft-lbf)||+/- 1,200|
|Max. Sampling Rate (sec)||1|
|Max. Number of Samples||400,000|
|Typical Battery Life (hrs)||40|
|Sampling Time @ 1 sec Rate (hrs)||9|
|Connections||2-3/8" PAC DSI|